This message was posted by gcannon on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/1052.html#000005 Go in under tools>settings>thread feed- after that try about 35 on the column feed (default is 40). I would also set the lower feed limit at 2 (default is 1) this may also help. The defaullts are 40 for column and 100 for run/fill. It is important to remember the lower the number in column feed, the more thread is fed, but the converse is true of the run/fill feed number- the higher the number the more feed. And the lower limit will not let the (auto) feed go any lower than what you set it. You may have to play around with these settings on a scrap of similar material before you get the result you want. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================