This message was posted by Greenwing on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/2/1527.html#000001 I am the one that was having the issue that Rod helped out. I did save the file in OFM and that is what created the problem. the AOS did not allow it to load properly. If I were to use the BLEND TOOL... I had to save it in both OFM and EXP OFM to edit EXP to stitch I ended up not using the BLEND tool as I fould if I used only custom density it saved OFM fine. And sewed fine. So I did the design in layers of single layer custom density. the only diff. I can see is I did the blending, Instead of the machine. I have the same version of DS as you do. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================