Hi Sometimes you may get a bit of dust in the little pins, I sometimes have the same problem, just gently blow on the card, that may fix it too. Not sure what else you can clean the cards with. Regards Adrien -----Original Message----- From: access-uk@xxxxxxxxxxxxx [mailto:access-uk@xxxxxxxxxxxxx] On Behalf Of Jibber Jabber Sent: Thursday, May 22, 2014 10:59 PM To: access-uk@xxxxxxxxxxxxx Subject: [access-uk] Re: victor reader problem Hi James, If no one comes up with a better solution, you could try taking your books eccetra, off your SD card, saving them into a folder on your pc, then put the card back into your Stream, and see if it will format it. If it cures the problem, great, however, firstly I would try another card in it to see how that works. Jim. Jim. -----Original Message----- From: James English Sent: Thursday, May 22, 2014 9:32 PM To: access-uk@xxxxxxxxxxxxx Subject: [access-uk] victor reader problem Hi, My victor reader always used to work without a hitch, but today it stopped reading my sd card. Whenever I put it in, it says please wait, and then stops responding. Without the sd card, it is working fine. My computer, however, is reading my sd card fine. Could you think of anything that could cause this? Is my victor readers sd carder broken? ** To leave the list, click on the immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** access-uk-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq --- This email is free from viruses and malware because avast! Antivirus protection is active. http://www.avast.com ** To leave the list, click on the immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** access-uk-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq ** To leave the list, click on the immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** access-uk-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq