exatly what i did but the braille terminal just freezes. blody anoying.
----- Original Message -----
From: Terry Clasper <dmarc-noreply@xxxxxxxxxxxxx> (Redacted sender
terry$clasper for DMARC)
To: access-uk@xxxxxxxxxxxxx
Date: Tuesday, 1 November 2016 8.02 am
Subject: [access-uk] pairing the touch with the IPHone
** To leave the list, click on the immediately-following link:-
Hi everyone and sorry I didn't get to writing this last night.
Here's what I did to get my Touch to work with my iPhone 7 using IOS10.2.
first on the touch went to quick settings and navigated to BlueTooth.
This w =on my Touch was turned off, so, I pressed the cursor router in the
empty box, to toggle it to on.
I then tried to connect using bluetooth in the terminal and it didn't work.
So, I went back to quick settings, bluetooth, and just after the on/off
toggle I saw an option about bluetooth device visibility, which seemed to be
set to off.
So, I changed this to five minutes, then, again backed out of bluetooth
settings.
I thin went back to the Braille Terminal, chose Bluetooth and then on my
iPhone went to voice over Braille.
I then saw the Brailliant device and was able to pair successfully.
I've not yet tried KNFB although I'm a bit concerned about the practicality
of holding a device as heavy as the touch above a document because of course
the camera is the middle recess on the bottom of the touch!
Hope this helps a bit!
!
** To leave the list, click on the immediately-following link:-
** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe]
** If this link doesn't work then send a message to:
** access-uk-request@xxxxxxxxxxxxx
** and in the Subject line type
** unsubscribe
** For other list commands such as vacation mode, click on the
** immediately-following link:-
** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq]
** or send a message, to
** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq
