If the problem has started to occur recently it may be to do with a recent update or new software installed that runs in your system tray. Occasiionally an application runnning in the system tray may cause K1000 to loose focus whilst it is reading and therefore when the using hits control or start/stop reading key to stop speech they have no control over the application. An alternative line of thought may be around the scanner, some non-Epson scanners will produce an interface during the scanning operation that causes K1000 to loose focus. Can you let us know which scanner you have. Regards. Tristram Llewellyn Sight and Sound Technology Technical Support www.sightandsound.co.uk ----- Original Message ----- From: "Petrina Delves" <aunk99@xxxxxxxxxxxxx> To: "access UK" <access-uk@xxxxxxxxxxxxx> Sent: Monday, September 19, 2005 7:23 PM Subject: [access-uk] Problem with Kurzweil. Hi all, I am using Kurzweil version 9.03. Please can someone tell me why, after Kurzweil had scanned the page, and started reading it, no matter what I did I could not get Kurzweil, to stop reading the scanned page. Thanks in advance for any help. All the best Petrina, Southampton UK ** To leave the list, click on the immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** access-uk-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq ** To leave the list, click on the immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** access-uk-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq