Well the strange thing is that it worked for a few seconds and then went off. ----- Original Message ----- From: Shaun O'Connor To: access-uk@xxxxxxxxxxxxx Sent: Tuesday, February 18, 2014 4:56 PM Subject: [access-uk] Re: Connecting NC10 to External Monitor two possibilities spring to mind 1) you could have a defective connector on the computer 2) there may be a fault in the graphics hardware inside your computer. the fact that the external monitor works well on another computer clearly rulesout a fult with the external monitor. hope that helps a bit. regars. Sean On 18/02/2014 16:45, Eleanor Burke wrote: I had an external monitor connected to my NC10, one morning when I turned on as usual both were displaying fine and then after a few seconds the monitor display disappeared to a blank screen. I have tried connecting the monitor to another laptop and it displays fine on the external monitor. Any suggestions please as clearly it is not a problem with cable or power supply. Strange thing is that the external monitor when connected to the NC10 displays initially No Signal and then goes off.