[access-uk] Re: Braille transcription programmesRe: Re: Braille transcription programme
- From: Christopher Maule-Oatway <c.maule@xxxxxxxxxxxx>
- To: access-uk@xxxxxxxxxxxxx
- Date: Fri, 25 May 2007 18:10:37 +0100
Hello Peter,
We seem to be talking about two different products here!
The web page that you quote belongs to a product called RC-Wintrans,
whereas the front-end to NFBTRANS is called Wintrans, and is
free! Again, I refer you to the site
http://members.toast.net/mlbx/winbt/
If you are not keen on using the dollar commands in Cypher, then you
will probably have the same reaction to using similar commands in
NFBTRANS, which, incidentally, are preceded by a tilda!
I did have the same problem as you with Winbraille. In my case it
was caused by the line of code printed at the top of the braille
document. It is some time since I used Winbraille, so can't quite
remember how I solved the problem. If you can hang on for a day or
two, i'll let you know.
Cheers,
Christopher
At 17:28 25/05/2007 +0100, you wrote:
Chris
Copied from the web page
The limitations of the Demo Edition are:
- The number of text entries that can be translated is limited
to 250.
What is your experience of this?
My problem with Winbraille was that it suddenly started
printing one line on a new page and then jumping to the next
leaving practically a whole blank braille page. I did have the
embosser checked by Dolphin and updated to the latest firmware and
programme versions. I also ensured that the page length on the
embosser was set to 13 inches for that size paper.
I do understand that the $ commands exist in Cyper but they are time
consuming to insert and they do not offer the style flexibility that
say WinBraille does.
Thanks to all for your contributions. I am gradually working through them.
Peter
** To leave the list, click on the immediately-following link:-
** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe]
** If this link doesn't work then send a message to:
** access-uk-request@xxxxxxxxxxxxx
** and in the Subject line type
** unsubscribe
** For other list commands such as vacation mode, click on the
** immediately-following link:-
** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq]
** or send a message, to
** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq
Other related posts:
