Hi Paul,
Just want to let you know that the following command will probably work in your
case too (from both the DOS command line and at the XyWrite command line with
U2 installed):
SETCFG USEDRVS=ON
The above command will automatically mount vDosPlus drives to Windows drives
that are not yet mounted as vDosPlus drives.
To unmount a specific vDosPlus drive, use the UNUSE command, e.g.
UNUSE F:
You can use the USE or SETCFG command to mount F: again later.
Hope this helps.
Wengier
On Feb 17, 2017, at 1:51 PM, Paul Breeze (Redacted sender "paul.breeze" for
DMARC) <dmarc-noreply@xxxxxxxxxxxxx> wrote:
Dear Carl
I have tried "SETCFG USE F: F:\" but it tells me:
Not a config option - USE F: F:\
Any ideas?
Thanks
Paul
On 17/02/2017 18:03, Carl Distefano wrote:
Paul,
My quest, as before, is to be able to save to and retrieve from a USB
drive that is not recognized by XY4 because it was not there when
VDosPlus was launched.
Ah. Now I understand. Yes, there is an easy solution. Just command
SETCFG USE d: d:\<Helpkey>
where "d" is the letter of the newly-added drive. You can then use
normal commands like DIR, CA, SA, etc.
I'm still going to overhaul the commands for CAlling, SAving, etc. long
filenames to create a single suite of commands that works under either
vDosPlus or CMD.EXE. I expect to post an update to U2 over the weekend.
