I have been a proponent of screwdrivers for awhile now on the list. Well this week, I finally ran into some problems with it. I did a 1.6 to FXP upgrade and ran into serious problems. I was wondering if other screwdriver's users had any advice. We print seriously complex documents for a mortgage application. The documents are multi-page and just about every combination of Letter, Legal, Landscape, and Portrait you can think of. SD 1.6 has worked well from an admin perspective (very stable), but the users hated specifying print orientation in the client. Documents are primarly printed from a MS Access XP application. The FXP upgrade caused serious flaky issues with the ICA client. Server side things were fine, but the ICA client was dropping out on client workstations because of ICA Virtual channel issues. Server side everything chugged along, but the documents never printed after killing the ICA client. Tricerat has reccomened upgrading printer drivers across the board (essentially, verifying the driver on every workstation), which is what we purchased SD to get away from originally. Has anyone else had these issues? Where driver updates the only way to solve the problem? Thanks, Brian Politis ********************************************** This weeks sponsor 99Point9.com 99Point9 helps solve your unresolved technical server-based questions, issues and incidents. http://www.99point9.com *********************************************** For Archives, to Unsubscribe, Subscribe or set Digest or Vacation mode use the below link. http://thethin.net/citrixlist.cfm