I must be missing something obvious here. I have a WTS 4.0 SP6, MF 1.8 new install (rebuild). I am trying to apply MF 1.8 SP3, but it won't run. I have tried installing from the control panel, and by double clicking on autorun and then clicking on the WTS button in the GUI, and from the command line. Each time I get an hour glass for a second and then nothing. No events in the event logs, no errors. The only difference I can see between this build and the last build is that I am rebuilding via a Compaq remote insight board. I am stuck on this one. I have tried starting over with no luck. Anyone have any ideas? Thanx, Paul ********************************************************* This Week's Sponsor - RTO Software / TScale TScale increases terminal server capacity. Get 30-40% more users per server to save $$$ and time. Add users now! - not more servers. If you're using Citrix, you must learn about TScale! Free 30-day eval: http://www.rtosoft.com/Enter.asp?ID=79 ********************************************************** For Archives, to Unsubscribe, Subscribe or set Digest or Vacation mode use the below link: http://thethin.net/citrixlist.cfm