[THIN] Re: CAG w/ AAC 4.2 problem accessing new network

You also need to add it as an accessible network. I can't remember if 4.2
is the same as 4.5, but in the AAC Config, right click on the Access
Gateway Node and select properties. You will find what you need in there.

Cheers.

 Kind regards,

 Jeremy Saunders
 Senior Technical Specialist

 Infrastructure Technology Services
 (ITS) & Cerulean
 Global Technology Services (GTS)
 IBM Australia
 Level 1, 1060 Hay Street
 West Perth  WA  6005

 Postal: PO Box 525, West Perth WA
 6872

 Visit us at
 http://www.ibm.com/services/au/its

 P:  +61 8 9261 8412                F:  +61 8 9261 8486
 P:  (Reception) +61 8 9261 8420    E-mail:
 M:  TBA                            jeremy.saunders@xxxxxxxxxxx










                                                                       
             "Tom Sorenson"                                            
             <tsorenson99@gmai                                         
             l.com>                                                     To
             Sent by:                  thin@xxxxxxxxxxxxx              
             thin-bounce@freel                                          cc
             ists.org                                                  
                                                                   Subject
                                       [THIN] CAG w/ AAC 4.2 problem   
             28/08/2007 09:32          accessing new network           
             PM                                                        
                                                                       
                                                                       
             Please respond to                                         
             thin@xxxxxxxxxxxx                                         
                     g                                                 
                                                                       
                                                                       




I'm having a problem with clients accessing a new network via our CAG/AAC
implementation.  I've edited the network resource to include the new
network and made sure it is part of the connection policy.  In the access
list on clients they can see the new network resource but are unable to
connect to it.  Attempts to connect to the new network get routed out of
the clients internet interface.  Any ideas or suggestions on why this is
not working?

Thank You

************************************************
For Archives, RSS, to Unsubscribe, Subscribe or
set Digest or Vacation mode use the below link:
http://www.freelists.org/list/thin
************************************************

Other related posts: