dont forget to ck the bias resistors on crt board, usually 120k or 82k. gary Gary Chambers Chambers T V Bradenton,Florida Since 1982 ----- Original Message ----- From: "Terry Joseph Hutchison" <sony1@xxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Monday, November 26, 2001 5:56 PM Subject: [TechAssist] Re: zenith sm2573bt > > Usually a bad tube will be to green or to red(USUALLY)in my experience. > Compare the CBE voltages on all three of your CRT drivers, odds are you > have lost the green or red. If all have the same values then I would > begina to suspect the crt. Good luck Terry > > Wilbert Bolden wrote: > > > > chasis 14-12181 > > got this zenith in plays well but picture all with blue color > > maybe bad crt i dont have a crt tester i found q503, q5104,q5105 discolored > > i can't read does any one know these values also does any one have schematic > > if so please e-mail. also does any one know what else to check. thanks > > wilbert > > bolden's electronic repair > > rt 1 box 55-d > > forkland,al 36740 > > wbolden@xxxxxxxxxx > > > > ================================= > > Help make your TechAssist database better! > > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > > ================================= > > To UNSUBSCRIBE your email address, click here: > > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > ================================= > Help make your TechAssist database better! > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > ================================= > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > ================================= Help make your TechAssist database better! Submit your fixes here: http://circuitwork.com/techassist/tip/#tips ================================= To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe