[TechAssist] Re: general question: changing memory accu's

Stefaan,

Unless I have misunderstood the problem, I believe that your concern is
directed to the wrong area. You should be more concerned with the corrosion
and the cause.

If you just replace the memory accu, won't the new accu corroded also?

Locate and eliminate the cause, then neutralize and seal the corroded area.

This should prevent further corrosion and possible part failure.

Paul W
C&W Electronics
Azle Tx


----- Original Message -----
From: "Stefaan Van Slycken" <vanslycken@xxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Friday, November 29, 2002 2:46 AM
Subject: [TechAssist] general question: changing memory accu's


> Hi.
> I'm working on a thomson ICC5, and i noticed the 2.4V accu is starting to
corrode.  I was wondering: if i desolder this accu, all the channel presets
will be lost, can i just put a new accu in parallel over the old one (on the
solder side of the chassis, there's room enough), or will the old one short
out eventually?
> BTW on this particual chassis the "loading circuit" consists of a simple
RC network so it should be able to handle the extra loading current.
>
> Thanks for your opinions...
> Stefaan Van Slycken
> Van Slycken Elektro, Belgium.
> ------------------------------------------
> To REMOVE your email address, click here:
>   http://www.tech-assist.org/unsubb.html
> To CHANGE your email address, click here:
>   http://www.techassist.net/forms/change.html
> ------------------------------------------
> ***NEW*** Tips Added Instantly!!!***
> Submit Repair Tips here:
> http://www.tech-assist.org/secure/tip/
>
------------------------------------------
To REMOVE your email address, click here:
  http://www.tech-assist.org/unsubb.html
To CHANGE your email address, click here:
  http://www.techassist.net/forms/change.html
------------------------------------------
***NEW*** Tips Added Instantly!!!***
Submit Repair Tips here: 
http://www.tech-assist.org/secure/tip/

Other related posts: