what's your voltage on emitter of tp15should be around 11 volts in standby.if not change it. al marquardt ampm@xxxxxxx ----- Original Message ----- From: "Junior E Hurdle" <jselectronics@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Sunday, May 05, 2002 10:53 PM Subject: [TechAssist] dead GE tv model #13gp239a chassis #tx826tb > hi techs , > this set came in with no power . I checked the 5v supply and found it to be just above 2 v .replaced trt03, 04, 05 and tp19. this restored the 5 v supply . But there is no voltage on the stand by line , nither is there a 9v supply to the signal processor. > also there is no voltage on the output of the power supply transformer . The raw b+ is 180v. > how do I get this power supply to work and what woltage should be on the standby ? > thank you > Junior hurdle. > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/