Check several bad caps on right side smps board. Most are leaking electrolitic fluid. If memory serves me its the 470@50 that cures most problems. Coach www.athometvservice.com 4975 W. 80th Westminster CO 80030 coach@xxxxxxxxxxxxxxxxxxx -----Original Message----- From: techassist-bounce@xxxxxxxxxxxxx [mailto:techassist-bounce@xxxxxxxxxxxxx]On Behalf Of repair1 Sent: Tuesday, May 14, 2002 4:41 PM To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] ck3526r dead degauss relay clicks Mitsubishi ck3526r, set is dead, push power, degaussing relay energizes nothing else, this set appears to have two smps, on one board on side of cabinet,one on def board, if I jump other relay(set has 2 relays) hv comes up, no audio, no raster, I can hear smps on right board chirp when you apply ac, but reg(ic9a1) has no output, just raw b+ on pin3 and a -6v on pin1, if any one has print for this set, since there is no sams, or any suggestions, I would greatly appreciate it . charles betzler Best Electronics repair1@xxxxxxxxxxxxx ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/