[TechAssist] Re: Zenith projection model Z60Z83D8 9-1674-01module

Correct on the CRX3412 and Horizontal O/P. Flyback was probably not the
culprit...suspect CRT....Classic.

-Ed-

Tel-Tek Electronics
    Midland, Ontario
     Canada.

teltek2@xxxxxxxxxxxx
teltek3@xxxxxxxxxxxx
teltek@xxxxxxx  

"Quality will be remembered....long after Price is forgotten"



Ttkirkpat@xxxxxxx  The above is the reply to your message dated    8/30/02
10:08 PM

> 
> Set had shorted horizontal out, bad flyback and shorted crx3412 diode.
> Replaced all with Zenith original- hooked up set and worked great for 35
> minutes. The horizontal output and crx3412 are shorted again. B+ voltages
> were all perfect. Any helpers who could suggest why there might be a repeat
> failure?? Thanks from Mike at the Video Center. My e-mail is ttkirkpat@xxxxxxx
> ------------------------------------------
> To REMOVE your email address, click here:
> http://www.tech-assist.org/unsubb.html
> To CHANGE your email address, click here:
> http://www.techassist.net/forms/change.html
> ------------------------------------------
> ***NEW*** Tips Added Instantly!!!***
> Submit Repair Tips here:
> http://www.tech-assist.org/secure/tip/

------------------------------------------
To REMOVE your email address, click here:
  http://www.tech-assist.org/unsubb.html
To CHANGE your email address, click here:
  http://www.techassist.net/forms/change.html
------------------------------------------
***NEW*** Tips Added Instantly!!!***
Submit Repair Tips here: 
http://www.tech-assist.org/secure/tip/

Other related posts: