[TechAssist] Re: Zenith projection model Z60Z83D8 9-1674-01 module

This is just my opinion and has been my experience with all zenith modules.You
probably have a few bucks invested in the bd and still has problems.You missed a
diode or cap in the smps ckt and thus the same problem again.Why not just order
eighter a rebuilt module from Module Exchange,PTS,TRI-State module for about
$90.00 and save time and more wasted money.The OEM bd are still pretty expensive
but the rebuilts are reasonable .
Before You order the new bd,try replacing the same parts again (hot,diode) and
before firing up the set,remove the crt modules and run it for some time and 
keep
an eye on the temp.of the hot.If its not too hot,then you may have a crt causing
the problem.Just my 2 cents worth.
Mando
Birdie's TV & Electronics
Casa Grande,az

Ttkirkpat@xxxxxxx wrote:

> Set had shorted horizontal out, bad flyback and shorted crx3412 diode.
> Replaced all with Zenith original- hooked up set and worked great for 35
> minutes. The horizontal output and crx3412 are shorted again. B+ voltages
> were all perfect. Any helpers who could suggest why there might be a repeat
> failure?? Thanks from Mike at the Video Center. My e-mail is ttkirkpat@xxxxxxx
> ------------------------------------------
> To REMOVE your email address, click here:
>   http://www.tech-assist.org/unsubb.html
> To CHANGE your email address, click here:
>   http://www.techassist.net/forms/change.html
> ------------------------------------------
> ***NEW*** Tips Added Instantly!!!***
> Submit Repair Tips here:
> http://www.tech-assist.org/secure/tip/

------------------------------------------
To REMOVE your email address, click here:
  http://www.tech-assist.org/unsubb.html
To CHANGE your email address, click here:
  http://www.techassist.net/forms/change.html
------------------------------------------
***NEW*** Tips Added Instantly!!!***
Submit Repair Tips here: 
http://www.tech-assist.org/secure/tip/

Other related posts: