Menu 999 Enter. Surf, Flashback, ummm.....the top 3 buttons above the numbers will select green blue and Save, the button below the 9 (source) is for red. Buttons 1-9 select the adjustment (pin, skew, linearity etc. Pressing the numbered buttons a 2nd time will bring up Sub-adjustments. Damon Brunger Telrad Electronic Services Ft Wayne, IN 46815 ----- Original Message ----- From: <Ttkirkpat@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, January 31, 2003 8:05 PM Subject: [TechAssist] Zenith projection model PVY5265RK- poor convergence > Set was dead, replaced flyback, hot and CRX3412 diode. Set now works however > convergence is poor on outer edges, particularly the red. I replaced the > convergence ic's and checked all the resistors which are good. 2 questions. > #1- somewhere I believe I read that something would get damaged in the > convergence circuit in conjunction with the above repair ??! Or #2, how do > you access the memory for touching up the convergence on the outer edges? > Pushing Menu 9876 will get you into the other factory settings but none of > these relate to convergence. Thanks to my helper from Mike at the Video > Center. My e-mail is ttkirkpat@xxxxxxx > > > ------------------------------------------ > Submit A Repair Tip For Everyone Here: > http://www.tech-assist.org/secure/tip/main.html > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > > ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html