Set was dead, replaced flyback, hot and CRX3412 diode. Set now works however convergence is poor on outer edges, particularly the red. I replaced the convergence ic's and checked all the resistors which are good. 2 questions. #1- somewhere I believe I read that something would get damaged in the convergence circuit in conjunction with the above repair ??! Or #2, how do you access the memory for touching up the convergence on the outer edges? Pushing Menu 9876 will get you into the other factory settings but none of these relate to convergence. Thanks to my helper from Mike at the Video Center. My e-mail is ttkirkpat@xxxxxxx ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html