If the filaments are lit, check the g2 voltage . should be ~ 350-400 volts. If 0v , pull crt board off and measure g2 again. If voltage returns crt shorted. Regards Jonas ----- Original Message ----- From: "Jeff Dougherty" <jeff@xxxxxxxxxxxxxxxxxx> To: "Techsonline" <techassist@xxxxxxxxxxxxx> Sent: Friday, November 09, 2001 7:28 PM Subject: [TechAssist] Zenith TV Mod# A25A11D, Module# 9-1790, Sams#4051 > > The above TV came with a black pix. Menu is fine, > High voltage is fine, Audio is fine but no Raster. I replaced EEPROM and > had no luck. > I checked data and clock pins from the tuner to see if the were shorted, > but they weren't. > > Jeff > mailto:Jeff@xxxxxxxxxxxxxxxxxx www.9-11-2001tragedy.com > FAX 1-413-280-0677 > Intrepid Video & Electronics > Harrisburg, PA 17111 > 717-909-8844 > www.intrepid-video.com www.tech-repair.net www.thetoolcaddy.com > > ***************************************** > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > ***************************************** > To UNSUBSCRIBE write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. ***************************************** Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips ***************************************** To UNSUBSCRIBE write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.