Jerry, This is not the same set, but probably close. Ck C2208(2.2uf),C2212(22uf) both on input of IC1200. One is sync coupling the other is afc coupling. Hope this helps. Paul W C&W Electronics From: "Jerry Mossburg" <mrcwmain@xxxxxxx> Reply-To: techassist@xxxxxxxxxxxxx To: <techassist@xxxxxxxxxxxxx> Subject: [TechAssist] Zenith SJ2743LK loses horiz. sync Date: Sat, 3 Nov 2001 11:03:13 -0600 Have an unusual problem, hopefully someone has seen before. Customer complained that set would lose horiz, sync in 5 to 15 minutes of power up, but if they went out and adjusted the DSS dish, picture would clear up for a few minutes. I did a sweep solder job on the 9-1092 ps/sweep module and the 9-1054 main module and the unit worked perfectly for over an hour, then started losing horiz. sync again. Is there a bad filter cap causing this? Didn't want to start swapping out modules if a capacitor was the only problem. Dish works perfectly on another set, so am satisfied problem is in this set. Thanks in advance to anyone that can help . Jerry Mossburg Mossburg Repair Center 114 N 16th St Bethany, MO 64424 660-425-4400 Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line. _________________________________________________________________ Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.