Found the problem, shorted Q3404 (121-1102A) between C-E. Replaced and working normally. Shaun Advanced Electronics 224 West Riverview Ave. Fort Morgan, CO 80701 ----- Original Message ----- From: "Shaun" <satguy@xxxxxxxxxxxxx> To: "tech" <techassist@xxxxxxxxxxxxx> Sent: Thursday, March 17, 2005 8:56 PM Subject: [TechAssist] Zenith B25A02Z----9-2143 turns partly on by itself > This set had some water damage with an open main fuse. Cleaned up water > damage and replaced fuse along with RX3404 (180k 1/2 watt). Set turns on > chassis when A\C is applied with a slick raster and no sound. When power > button is pushed degaussing engages and picture comes on normal with sound. > If I try to turn it off the picture stays on but the sound turns off just > like if a power relay was stuck closed but there is no power relay only the > relay for the degaussing. I need a print or partial of the power supply if > someone has one. > > thanks > Shaun > > Advanced Electronics > 224 West Riverview Ave. > Fort Morgan, CO 80701 > > -------------------------------------------------------------------------- --- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/