[TechAssist] Re: ZENITH Z19A11S chassis GA Z line

Bill, I was wrong on sams # it is 4014,
I replaced R3211 with a substitution box had no horiz.sweep.(Vert line down
middle.) run sub box all the way down to 15 ohms got full picture?I put a
10k resistor in still had no sweep.Then I put a 15 ohm resistor in,and had
sweep.But it burned up.I put a 5.7 ohm 10 watt in, It works good but getting
hot.Maybe a cap pulling to much current?any idea which one.
thanks,Richard

----- Original Message -----
From: "Bill Boyd" <billstvs@xxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Tuesday, January 15, 2002 3:32 PM
Subject: [TechAssist] Re: ZENITH Z19A11S chassis GA Z line


>
> R3211, 10K 1/2W, connects from C3216, 2.2uf 160V, to
> L3201 and 3Y3-2
>
> D3209, 103-284A, also connects from C3216 to the other end of L3201
>
> Have zenith manual if you need further help.
>
> HTH
> Bill
> Bill's TV Service
>
>
> At 10:35 PM 1/14/02 -0800, you wrote:
>
> >
> >I don't have the SAMS 4041 for this tv.
> >Zenith z19a11s  chassis ga z line ? Came in with hole
> >burned in pc board and burned component. the component
> >is a diode or risistor? I can not tell.one end comes
> >from the cap.c3216 2.2uf/160v.and goes to L3201 and
> >3Y3.Has 99v on 3y3 end -5v? on other.
> >  Had vert.line down the middle,(no horiz.)replaced
> >cap. and guessed 116 diode?, worked good.then
> >had line again?(no horiz.)I don't know if yoke or fly,
> >is bad or i am replacing wrong diode.any help
> >appreciated.thanks,
> >Richard
> >
> >=====
> >Richard Golden
> >Golden Video Repair Center
> >1214 e. 6th street
> >ontario ca. 91764
> >(909)988-3356
> >
> >reldong@xxxxxxxxx
>
> ------------------------------------------
> Make your TechAssist database better!
> Submit Repair Tips here: http://www.tech-assist.org/secure/tip/
> ------------------------------------------
> To UNSUBSCRIBE your email address, click here:
> mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe
> Or send a BLANK email with unsubscribe in the
> SUBJECT field to the address above.

----------------------------------------------------
Sign Up for NetZero Platinum Today
Only $9.95 per month!
http://my.netzero.net/s/signup?r=platinum&refcd=PT97
------------------------------------------
Make your TechAssist database better!  
Submit Repair Tips here: http://www.tech-assist.org/secure/tip/
------------------------------------------
To UNSUBSCRIBE your email address, click here:
mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe
Or send a BLANK email with unsubscribe in the
SUBJECT field to the address above.

Other related posts: