Ty, Check the tension band, perhaps it is missing or torn. Check the tension arm, perhaps it is not in load position, missing spring..not in line, etc. Jeff -- Intrepid Video TV/VCR Repair 263 S Front St, Steelton PA 17113 717-939-7708; (F) 717-564-4952 www.intrepid-video.com www.tech-repair.net ----- Original Message ----- From: "Ty" <ty1k@xxxxxxxxxxx> To: "Techassist" <techassist@xxxxxxxxxxxxx> Sent: Tuesday, June 22, 2004 1:04 PM Subject: [TechAssist] VR9160 Magnavox - Tracking fails to lock on. This is the one that has the circuit board that lifts up like a car's hood. Thing came in for eating tapes. The Idler drag clutch was bad. I fixed the mechanicals, Now it won't lock on. I am pretty sure the problem is the PG pulls shaper cap that is usually on the Capstan motor. Does anyone remember where this cap is located on the board? I had the manual for this series, whit all my notes, but can not remember whom to remind to return it. Thank you for your time and effort. Ty Tiberius Kraemer BLUE STAR ELECTRONICS 3312 Silverton Rd. NE Salem, Oregon Phone: 503 391 1491 Mailto:ty1k@xxxxxxxxxxx ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/