Hi All This set came in with no vertical sweep. I checked the IC401 LA 78401 voltages were ok except pin3 voltage is low only .6 volts. Vertical drive signal was also not clean. I changed the chroma IC and the vertical output and I have the same problem. I have also low voltage from IC601 Vertical out pin 38 suppose to be 5 volt but I am getting only 4V. I don't know if the new IC is bad if I have to order another one and keep replacing the Jungle. I am hoping some other tech worked on vertical section and had the similar problem. Just want to know if any vertical repair tips for this set. TIA -----Original Message----- From: techassist-bounce@xxxxxxxxxxxxx [mailto:techassist-bounce@xxxxxxxxxxxxx]On Behalf Of Alltv Sent: Monday, June 06, 2005 10:25 AM To: Techassist@xxxxxxxxxxxxx Subject: [TechAssist] Toshiba TV combo MW24FM3 Vertical problems ************************************* All TV Appliance Service Ken Dinckan 2747-B Roosevelt Street Carlsbad CA, 92008 (760) 434-1131 ---------------------------------------------------------------------------- - This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/