[TechAssist] Re: Toshiba CX27f60 TAC9605 saving service parameters FIXED
- From: "Leonard G. Caillouet" <lcaillo@xxxxxxxxxxxx>
- To: <techassist@xxxxxxxxxxxxx>
- Date: Thu, 14 Nov 2002 13:53:41 -0500
I finally got this one fixed. I ordered the Microprocessor QA01 and it
still would not hold memory. I went back to the original EEPROM and it
worked. Apparently the EEPROM that I got was either a bad sub or defective.
To summarize:
Dead set after lightning. Replaced
Q801
D875
F860
Q843
QA01
Thanks for all of the help and suggestions.
Leonard G. Caillouet
Service Manager
Electronics World
Gainesville, FL
352-332-5608
352-332-5668 (fax)
----- Original Message -----
From: "tvservice" <tvservice@xxxxxxxxxxxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Thursday, October 24, 2002 5:29 PM
Subject: [TechAssist] Re: Toshiba CX27f60 TAC9605 saving service parameters
>
> Leonard I am ASC for Toshiba
> and to save alignment parameters after adjustments just turn power off at
tv
> or remote and power back on.
> If the are not being saved you may have a bad EEPROM, Micro or maybe +5v
or
> reset problem.
> I have had a bad micro fix this same problem in one TV.
> On micro +5volts is pin 42, reset pin 33 should be +5v
> Micro # 23905405 TMP87CM34AN3245
> EEPROM # 23904942 24LC04BI/P
> both may sub check with your supplier
> I use Fox International
>
> good luck
> Robert
> tvservice@xxxxxxxxxxxxxxxxxxx
> H & H Electronics Inc
>
> ----- Original Message -----
> From: "Leonard G. Caillouet" <lcaillo@xxxxxxxxxxxx>
> To: <techassist@xxxxxxxxxxxxx>
> Sent: Thursday, October 24, 2002 3:15 PM
> Subject: [TechAssist] Toshiba CX27f60 TAC9605 saving service parameters
>
>
> >
> > I'm trying you all again out of desperation. I have this set that we
have
> > fixed and works fine but we cannot get the service parameters to save to
> the
> > EEPROM (which has been replaced). I suspect that we are not using the
> > proper procedure for this chassis, since we have no manual, and the ones
> we
> > do have all have a different procedure. The service manual is NLA and
> > Toshiba will not talk to a non-ASC. If any of you are ASC for Toshiba
and
> > ahve a manual could you pass on the info needed? There are no Toshiba
> ASCs
> > nearby.
> >
> > Thanks,
> >
> > Leonard G. Caillouet
> > Service Manager
> > Electronics World
> > Gainesville, FL
> > 352-332-5608
> > 352-332-5668 (fax)
> >
> >
> >
> > ------------------------------------------
> > To REMOVE your email address, click here:
> > http://www.tech-assist.org/unsubb.html
> > To CHANGE your email address, click here:
> > http://www.techassist.net/forms/change.html
> > ------------------------------------------
> > ***NEW*** Tips Added Instantly!!!***
> > Submit Repair Tips here:
> > http://www.tech-assist.org/secure/tip/
> >
>
> ------------------------------------------
> To REMOVE your email address, click here:
> http://www.tech-assist.org/unsubb.html
> To CHANGE your email address, click here:
> http://www.techassist.net/forms/change.html
> ------------------------------------------
> ***NEW*** Tips Added Instantly!!!***
> Submit Repair Tips here:
> http://www.tech-assist.org/secure/tip/
------------------------------------------
To REMOVE your email address, click here:
http://www.tech-assist.org/unsubb.html
To CHANGE your email address, click here:
http://www.techassist.net/forms/change.html
------------------------------------------
***NEW*** Tips Added Instantly!!!***
Submit Repair Tips here:
http://www.tech-assist.org/secure/tip/
Other related posts:
- » [TechAssist] Re: Toshiba CX27f60 TAC9605 saving service parameters FIXED
