Replaced the F2 PIP pcb cured problem,part # 243872. Country TV Ron Miller Inez, TX. 77968 ----- Original Message ----- From: "Ron Miller d.b.a. Country TV" <rlmbkm@xxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, December 11, 2003 2:29 PM Subject: [TechAssist] F36665 CTC203X1, error code 16, need F 2 PIP info > This set was not starting up and staying on, hooked up chipper check and > pulled codes got code 16 all three lines :bus or clock line being held low. > Forced set on by injecting 12 vdc at U14104 pin 3. found clock line reading > of .073vdc isolated the problem to the F2PIP assy, my FREE sams dose not > show it, what goes bad on these or replace it. > Country TV > Ron Miller > Inez, TX. 77968 > > > **************************************************************************** * > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ***************************************************************************** Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/