[TechAssist] Re: TA Mitsubishi VS4543 jagged lines...was. Green focus

Update on this one...I hope someone can help me finish this repair..
I fixed the focus but rotating the lens on the green CRT.
I applied HV putty to the cups of the rebuilt CRT's. Now, I can't hear the hiss 
for the HV, but when
displaying a cross hatch, the vertical lines are jagged looking(all three 
CRT's), the horizontal lines are
fine and steady..
Could this still be  a HV reg problem, or something else on the board.. A small 
amount of fluid did leak
on the board and it wasn't too hard to clean the little bit of fluid up...
Perhaps this is a setting in the menu for H-freq...? I know how to get into the 
service menu, but no print
for this unit.
Thank you.
Jeff
--
Intrepid Video TV/VCR Repair
263 S Front St, Steelton PA 17113
717-939-7708; (F) 717-564-4952
www.intrepid-video.com  www.tech-repair.net
----- Original Message ----- 
From: "Intrepid Video Support" <support@xxxxxxxxxxxxxxxxxx>
To: "Techassist" <techassist@xxxxxxxxxxxxx>
Sent: Tuesday, May 25, 2004 12:06 PM
Subject: [TechAssist] TA Mitsubishi VS4543 Green focus


Hello...
I just replaced two CRT's on this unit from PatX. Now, I can't get the green to 
focus and very so often, I
hear a POP, CRT's go out and come back on a split second later.
Could this be the result of a defective green CRT?
Also, I think I will nee the manual for this. I went into the service menu and 
it appears accidentally
reset the EEPROM and I loss channel three reception(couldn't see my cross hatch 
from the generator any
more) and all convergence lines went bowed.
I rarely see Mitsubishi's, so I'm not sure where to go from here...since it's 
just me, I can not bring the
set in.
Any assistance appreciated..
Thank you.

Jeff
--


-----------------------------------------------------------------------------
Lost Password:
http://www.tech-assist.org  and select "Login Problems?".
Email Archives:
http://www.freelists.org/archives/techassist/

Other related posts: