If you scope the collector of the HOT ,with every connected normally , can you see the collector waveform? Is it distorting? ================================= Jeff Stielau Shoreline Electronics Repair 344 East Main Street Clinton,CT 06413 (860)399-1861 (860)664-3535 FAX jstielau@xxxxxxxx ================================= ----- Original Message ----- From: "Bob@Bobs tv" <woodman1@xxxxxxxx> To: "TechAsist M" <techassist@xxxxxxxxxxxxx> Sent: Thursday, October 14, 2004 12:33 PM Subject: [TechAssist] Sony KV32FS13 Dead > KV32FS13 > SCC-S40--QA > This set appears to have a over current problem, when the > power is turned on set comes on then clicks off with two blinks.. When > turning on, the B+ changes so fast you can not read on meter...Monitoring > the HV at turn on, the HV does not try to come up. Unhooking HOT the B+ > goes to 135V for aprox 5 seconds then shuts down again.. Did a visual > check along with static check of semis, but that is as far as I gone.. > Would appreciate any help on how to proceed, as this is a new set to me... > Using a KV32FS12 manual... > > Thank You > > Bob, > > Bobs TV Worcester, ma > > woodman1@xxxxxxxx > > Main 508-853-1482 > Fax 508-853-1480 > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/