Service manual sez 2 blinks is over current and may be a shorted HOT or a shorted IC702 on the CA board. ******************************************************************************************************************* Since 1972 Jim Myers Telrad Electronics Fort Wayne, Indiana Bob@Bobs tv wrote: > KV32FS13 > SCC-S40--QA > This set appears to have a over current problem, when the > power is turned on set comes on then clicks off with two blinks.. When > turning on, the B+ changes so fast you can not read on meter...Monitoring the > HV at turn on, the HV does not try to come up. Unhooking HOT the B+ goes to > 135V for aprox 5 seconds then shuts down again.. Did a visual check along > with static check of semis, but that is as far as I gone.. Would appreciate > any help on how to proceed, as this is a new set to me... > Using a KV32FS12 manual... > > Thank You > > Bob, > > Bobs TV Worcester, ma > > woodman1@xxxxxxxx > > Main 508-853-1482 > Fax 508-853-1480 > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/