[TechAssist] Re: Sony KV-32FS12 no 5V standby (dead)

Did you check C062 that connects from pin 3 to ground? If the labels are
correct pin 2 should go high at plug in then low since the label "RESET"
with no bar over it means the active state is high.
**************************************************
Jim Myers
Since 1972
Telrad Electronic Services Co.
Fort Wayne, IN 46815
*************************************************
----- Original Message -----
From: "Lynn C. Hedspeth, CET(r)" <HedTV@xxxxxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Thursday, January 30, 2003 5:28 PM
Subject: [TechAssist] Sony KV-32FS12 no 5V standby (dead)



Sony KV-32FS12

Set will not turn on because it has no 5v standby. IC002 is the standby
regulator IC and it has a good supply to pin 4 (input), but 0v on pin 5=
 (output).
I replaced IC002 but still no standby 5V.

I can input 5v at pin 5 and the set will play. I have even jumpered from=
 pin 4 to
pin 5 with a 120ohm resistor to limit the current and check for loading,=
 and it
still plays fine.

Short of deciding that the new IC002 is defective, does anyone have any=
 other
suggestions. (I ordered the OEM Sony part number 875966329)

Just for info, the voltages are exactly correct with the 120ohm resistor in=
 place.
7.5v pin 4
5v pin 5.

There is no 5v reset on pin 2 of IC002 (0V), but neither the micro or the=
 couple of other
components hooked to pin 2 is loading it down. And since this voltage is=
 supplied internally
by the IC, I am assuming this just a secondary issue related to the missing=
 standby 5v.


Thanks in advance for any help.
****************************************
Lynn C. Hedspeth, CET NC-407
Hedspeth Enterprises Inc.
3521 E. Hwy 27
Lincolnton, NC  28092-7659
704-735-3532
413-828-0216 (fax)
HedTV@xxxxxxxxxxxxx
***************************************
------------------------------------------
Submit A Repair Tip For Everyone Here:
http://www.tech-assist.org/secure/tip/main.html
------------------------------------------
To REMOVE your email address, click here:
  http://www.tech-assist.org/unsubb.html
To CHANGE your email address, click here:
  http://www.techassist.net/forms/change.html

------------------------------------------
Submit A Repair Tip For Everyone Here:
http://www.tech-assist.org/secure/tip/main.html
------------------------------------------
To REMOVE your email address, click here:
  http://www.tech-assist.org/unsubb.html
To CHANGE your email address, click here:
  http://www.techassist.net/forms/change.html

Other related posts: