Discharging Anode to Focus pin corrected the problem,although I had to discharge the Anode to BOTH focus pins. Adjusting both Focus Controls,and the G2, leaves a 'like-new' picture Peggs At 01:53 PM 2/25/05, peggs wrote: >G2 Voltage is being pulled down by the Pix Tube.......or the Fly can't >handle the load of the Tube. >G2 Voltage is app. 2v with CRT PCB connected,and app. 350v with CRT PCB >disconnected. >G2 voltage is adjustable either way. >G2 pin does not measure any leakage to ground. > >I'm thinking of trying the RCA/GE Focus/Screen tube problem trick by >(with CRT PCB disconnected) ground the G2 pin,unplug the set and discharge >Anode onto the Focus pin(s). Although there is no leakage between the G2 >pin and the Focus >pin(s) either. > >Suggestions ??? > > >Peggs >Peggs' Electronics >1519 West 2nd Street >Owensboro,KY 42301 >270-926-4968 >fax 270-686-7399 >peggs@xxxxxxxxxxxxx > >-- >This message has been scanned by the OMU Online postini filter. > > >----------------------------------------------------------------------------- >Lost Password: >http://www.tech-assist.org and select "Login Problems?". >Email Archives: >//www.freelists.org/archives/techassist/ -- This message has been scanned by the OMU Online postini filter. ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/