I have a problem with a Sanyo that I have not seen before. The horz.lines of the raster (with no antenna) wil very on the sides. Some times they will be anywhere from one half inch up to one and one half inchs short on the sides. For example one line will quit about one in from full width, the next one may be one half inch short and an other may be twice as far out. This happens all the time with out video. When I put RF or AV video some times it will be alright but eventully it will show up and be worse then when only raster. Several things I have done 1.changed the yoke and the flyback 2. change rth signal processor (LA7673). 3. Checked or changed most of the components in the horz. and power sup ccts. Can't see anything on the scope , so I have myself a little problem. I dont know where to look. If anybody has run into this or any thing of this nature would sure appreciate any help Buck Pasher Buck's T.V. Service Gander NF Canada spasher@xxxxxxxxxxxxxxxxx ***************************************** Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips ***************************************** To UNSUBSCRIBE write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.