What is the B+ voltage? If it too high it will kill HOT again. Frank --- Shaun <ssroark@xxxxxxxx> wrote: > > This Sanyo DS27630 came in with a shorted horz. > output and R608 and R610 > burned and open. When all parts replaced unit played > for about 1 hour then > shorted the horz. output again and blew the fuse > this time. I replaced it > again and checked again for and cold solder joints > and measured the base of > the horz. output (D1555) and it was > (-0.03vdc) and after about 10 > minutes it was starting to get hot to the touch. I > do not have a schematic > so I am shooting in the dark. I also replaced the 1 > uf 160 cap off of the > horz. driver transformer. Any help would really br > great. > > Shaun > Advanced Electronics > Fort Morgan, CO 80701 > (970)867-3124 > ssroark@xxxxxxxx > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ __________________________________________________ Do You Yahoo!? LAUNCH - Your Yahoo! Music Experience http://launch.yahoo.com ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/