Patrick;one componet I forgot to mention was R007,it's a 5.6 ohm 2 watt off pin #3 of your reg...Don of HARTS-TVCR''ASC'' ----- Original Message ----- From: "W. Blakey" <wblakey@xxxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, November 28, 2001 9:24 PM Subject: [TechAssist] Re: Sanyo AVM-2595U - bad regulation. > > What about the 25w resistor that bypasses current around the STR regulator? > Wilf Blakey/Blakey TV,Kirkland Lake,Ont > wblakey@xxxxxxxxxxxxxxxx > > ----- Original Message ----- > From: "Patrick Fugere" <p_fugere@xxxxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: November 28, 2001 6:24 PM > Subject: [TechAssist] Sanyo AVM-2595U - bad regulation. > > > > > > Hi, > > > > Sanyo AVM-2595U with bad regulation. > > Received the set dead. HOT was short so I replaced it. Now it goes on but > > very bad regulation. The brighter the screen gets the smaller and more > > distorted the image is.(squeezed pin). > > I replaced IC001 ( STR30130 ) and still the same . So I replaced the > nearby > > cap C007 and no dice. > > > > What else could be causing this. The original HOT is D1879 but I > replaced > > it with one I had in stock which has similar specs D1880. Could this be > it? > > I would doubt it but... > > > > Any help appreciated. > > > > Patrick Fugere > > F u j i s t i c s > > Montreal, Canada. > > p_fugere@xxxxxxxxxxxx > > > > > > > > > > > > > > > > > > > > ================================= > > Help make your TechAssist database better! > > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > > ================================= > > To UNSUBSCRIBE your email address, click here: > > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > > > > ================================= > Help make your TechAssist database better! > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > ================================= > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > ================================= Help make your TechAssist database better! Submit your fixes here: http://circuitwork.com/techassist/tip/#tips ================================= To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe