Last attempt on this model: This unit has a good picture and operates well in AC, but when DC is applied it is dead. I have 12 volts at the plug on the board and to D513 after that no sure no schematic. Anyone seen this before, or have a print on it? Shaun Advanced Electronics 224 West Riverview Ave. Fort Morgan, CO 80701 ----- Original Message ----- From: "Shaun" <satguy@xxxxxxxxxxxxx> To: "tech" <techassist@xxxxxxxxxxxxx> Sent: Tuesday, September 28, 2004 11:28 PM Subject: [TechAssist] Sansui COM311AD works on AC but dead on DC (2nd try) > This unit has a good picture and operates well in AC, but when DC is applied > it is dead. I have 12 volts at the plug on the board and to D513 after that > no sure no schematic. Anyone seen this before? > > Shaun > > Advanced Electronics > 224 West Riverview Ave. > Fort Morgan, CO 80701 > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/