Check DZ806, 15v 1/2w zener diode. I had this before on this set but usually the B+ will be low. Kevin Gunn Star Tek Electronic Services 390 Springbank Drive London, Ontario www.ulurn.com/startek N6J 1G9 519-473-6366 ----- Original Message ----- From: "D Trippel" <dtrippel@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, October 01, 2004 6:52 PM Subject: [TechAssist] Samsung TXE2546 Dead > Hello everyone > > I am working on a txe2546 that is going into shutdown about 2 seconds > after startup. B+ is 130v . Power supply checks good, vertical ic is > good . The front panel led blinks a few times after shutdown. The set > will not run at reduced ac either. I have heard that the flybacks are a > problem with this set. I have repaired a few of these sets , but > normally the vertical ic is bad. If anyone has any Ideas I would > appreciate it. > Don Trippel > Don's Electronics > Rosthern,Sask > Canada > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/