Along with the other suggestions, make sure you tighten all screws that ground the pcb's to chassis, especially the ones through the heat sink & actually solder them in place. Gary Carson City TV-VCR 2164 E Hwy 50 Carson City, NV 89701 (775)887-9089 fax (775)887-1067 ----- Original Message ----- From: "K Dinckan" <kdinckan@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, May 08, 2002 11:48 PM Subject: [TechAssist] SONY RECEIVER STR-DE 925 DISPLAY S PROTECTOR > Hi All > This receiver has protector on display after it is turned on in about 2 seconds. Re soldered all solder connections on input board. and found two dried caps C689 and c639 > replaced no change > any body know or experienced same problem and share the info with me. I will be very appreciated. > Thank you very much > Ken Dinckan > > e-mail to : kdinckan@xxxxxxx > > All TV&Appliance Service > 2747 Roosevelt Street # B > Carlsbad CA 92008 > Tel:(760)4341131 > Fax:(760)4348856 > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/