Do you have a manual? If you do check the 6.8 volt horizontal startup Voltage. CR4164. Al Marquardt ampm@xxxxxxx Al Marquardt Electronic Repair 206 W Main Girardville Pa. 17935 ----- Original Message ----- From: "junior hurdle" <jselectronics@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, October 30, 2003 10:03 PM Subject: [TechAssist] RCA model#F19430 (ctc156B) set dead > hi techs. > I have had worked a few of these RCA mod# F19430 sets that were dead. > normally the reg is shorted . But with this one the reg is good , and you can hear the > power supply start up when you plug it in.when I switch it on all happens is the degaussing > relay cuts in for a few secs but nothing else . it has the 5v for the eeprom and the sys control . > this set carries a GCT841B ic for the signal and deflection and I am not familiar with this ic. > can any one tell me if there is suppose to be a standby voltage on this ic , or Evan the pin out > for this . > **************************************************************************** * > Classifieds! Buy or Sell! > http://sell.tech-assist.org > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/