One side of filament is ground. Filament power comes from FBT through 1 ohm resistor RL12 to filament.. Filament voltage from FBT goes to x-ray circuit. Voltage at filament also goes through 680 ohm resistor RC08 to several other circuits. Jerry Silverman Greentron Inc 4 Newland Ave Greenville SC 29609 864 232 3889 Fax 271 2080 mailto:greentron@xxxxxxx ----- Original Message ----- From: "Terry H." <tvdoc@xxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, May 03, 2002 8:24 AM Subject: [TechAssist] RCA combo T19060GY, no filament... > I know 'no filament' is oversimplifying. Unit has HV, sound and vertical. Everything including video amps are operating like everything is fine, but no raster. Had good video once for 10minutes or so, then went out. Tried to be clever and floated the heater pins and did the wrap around the fly core.I had 1/4 screen but smeary at that. Changed the fly, but nothing. Checked continuity from the fly out and it's good. Of course no prints so could use a pointer or maybe a scan of the sweep circuit. Man I hate these. Any help appreciated. Thanks. > Terry H. > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/