This is for info only, also posted to members area The hv would come up and then shutdown with 3 pulses. Monitoring EHT line from flyback at pin 10 of connector BL111 from deflection board to small signal board measured only +15 volts before shutdown. This is normally around +26 volts. according to Tech-Line Found resistor RL044 on deflection board off pin 10 same connector had increased in value to 650K ohm should be 221K ohm this resistor is located under heatsink for vertical IC To temporarily defeat shutdown (FOR TEST ONLY) short transistor TV852 B-E on small signal board location H-7 Robert tvservice@xxxxxxxxxxxxx H & H Electronics Inc ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/