Vertical drive comes from IV001 pin 22 thru RV006 (1.8K-1/10 w) to BV001 pin 1.(860mv P/P) . Also there is TV030 at that point that could short the signal to ground. On the defl module vertical drive comes in on pin 1, thru RF517 (470 ohm) to the vertical output pin 4. B+ for the output is +26v on pin 2 coming from flyback pin 10 thru DL45 and RL46. IF01 (TA8403K) is a common failure. John. John Mielke Main TV 636 main St. Longmont, Co phone 303 776 6955 fax 303 776 0792 maintv2004@xxxxxxxxxxx ----- Original Message ----- From: "Bob@Bobs tv" <woodman1@xxxxxxxx> To: "TechAsist M" <techassist@xxxxxxxxxxxxx> Sent: Thursday, June 17, 2004 9:45 AM Subject: [TechAssist] RCA Combo T19408 Vert Sweep Help > RCA T19408/Combo > No vert sweep, then shut down. > Working on this unit with no print, (before shut down) Found no drive to the vert output TA84303K... On the main board, the set uses a TA1268 chip pin 22 (vert drive) has a nice clean 2v p/p at turn on.. But tracing thru the main board I can't find it anywhere else. Any help greatly appreciated or a print of the main board.. I had the same model a few months ago with no vert/sweep and found a small resistor in the vcc feed open.. > > Bob, > > Bobs TV Worcester, ma > > woodman1@xxxxxxxx > > Main 508-853-1482 > Fax 508-853-1480 > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/