Jose, HEAT the area around U16201 if it temporarily causes/fixes the problem then remove C14501 & C14503 and clean the adhesive/glue off the board, check/replace the caps. Hope this does it for you, Larry E. American TV & Electronics Crystal River, Fl. Jose Reyes wrote: >We have a CTC197, the problem is: After warm up (30 minutes or so) the >vertical starts to come up from the bottom and compress on top of the pix. > We have replaced the U16201,U14501,CR14501,CR14701,CR14730 with no luck. The > problem clears up a bit when we freeze U16201. The voltages feeding these two > ic's does not change with temp. >You guys have any suggestions?? >Thank you, > >Jose' Reyes >@ Kwik Fix TV > 619 Pondella Rd. > N. Ft. Myers, Fl. 33903 > E-Mail: jr@xxxxxxxx > jr@xxxxxxxxxxx > > >------------------------------------------ >To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html >------------------------------------------ >***NEW*** Tips Added Instantly!!!*** >Submit Repair Tips here: >http://www.tech-assist.org/secure/tip/ > > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/