Hi Keith. A couple of things to do and check. Resolder all Horizontal Driver Transformer connections. Check CR3104. Ken Taylor Zap electronics kntaylor@xxxxxxxxxxxxxx ----- Original Message ----- From: "Keith Trumbla" <ktrumbla@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, May 28, 2002 3:22 PM Subject: [TechAssist] RCA CTC146 shutdown > > Set runs for about 2 seconds then shuts down. I don't have a schematic but > B+ checks 130V under load. Tried CR4118 run diode as well. After repeated on > off cycles, set shows blank raster with retrace and proper audio. > TIA > > Keith Trumbla > O/O B.E.M Electronics Est.1954 > 839 Ellice ave. > Winnipeg Manitoba, Canada R3G 0C3 > Ph.(204)775-2875 Fax(204) 774-9192 > Mail to : ktrumbla@xxxxxxxxxxx > > > _________________________________________________________________ > MSN Photos is the easiest way to share and print your photos: > http://photos.msn.com/support/worldwide.aspx > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.tech-assist.org/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/