I strongly suggest you replace both Convergence IC's STK392-110 Robert tvservice@xxxxxxxxxxxxx H & H Electronics Inc ASC Panasonic ----- Original Message ----- From: "Phillip R. Hull" <phil245@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, June 11, 2004 3:55 PM Subject: [TechAssist] Panasonic PT-56WX51E Fix bad convergence FYI > This set came with bad blue convergence and I noticed that R7059 a 2.2 ohm > resistor was real hot compared to the other resistors in the red and green > circuits. After further checking I found that pin 12 of IC7106 the BH > convergence > out to the blue output IC was not 12K to ground like the Red and Green. > This being a double sided board I resoldered all the little flow thru > connector under IC 7106 and that reconnected PIN 12 to the rest of the > circuit and repaired the unit. So be on the look out for other problems > like this on these double sided boards. > > Phillip R Hull STET > phil245@xxxxxxxxxxxxx > FAX 517--569-3075 > Professional Technicians only > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/