This set came with bad blue convergence and I noticed that R7059 a 2.2 ohm resistor was real hot compared to the other resistors in the red and green circuits. After further checking I found that pin 12 of IC7106 the BH convergence out to the blue output IC was not 12K to ground like the Red and Green. This being a double sided board I resoldered all the little flow thru connector under IC 7106 and that reconnected PIN 12 to the rest of the circuit and repaired the unit. So be on the look out for other problems like this on these double sided boards. Phillip R Hull STET phil245@xxxxxxxxxxxxx FAX 517--569-3075 Professional Technicians only ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/