You may have to "Electrically Re-center" your crosshairs, then use the Static Alignment Rings on the CRTs to "Mechanically Re-center" the cross hairs. Repeat failures like this and Zenith Techs always recommend this procedure. Takes the stress off of the amps when they are adjusted to the center of their operating point. Damon Brunger Telrad Electronic Services Ft Wayne, IN 46815 ----- Original Message ----- From: "Janet Fantauzzi" <fantaj@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, December 02, 2003 5:48 AM Subject: [TechAssist] PV5263RK Module 9-1473 Poor Red convergence/Focus > Red would not move replace STK391-020 red convergence IC > on the 9-1473 PCB set played about a hour and back to the same thing. appreciate any help I can get. > Thanks > fuzz > Fantaj TV > Belle Vernon, PA. 15012-9669 > retired > fantaj@xxxxxxxxxxxxx > **************************************************************************** * > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ***************************************************************************** Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/