Did you check the alignment of the switches? Check for bad solder on the control board. Al Marquardt ampm@xxxxxxx Al Marquardt Electronic Repair 206 W Main Girardville Pa. 17935 ----- Original Message ----- From: "Roger G" <rogerfixit@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, June 29, 2004 9:39 PM Subject: [TechAssist] Re: More help needed -GE JVM140H Range hood Spacemaker 1400 No heat. > Subbed all micro switches - no better - actually, now acting weirdly. > > Set time cook - hit Start. Unit starts up but no heat. > If I open the door, fan stops, light comes on BUT timer keeps counting down !! > If I close the door, power starts up without having to hit START - still no > heat. > If the door is open when the time runs out, a relay clicks. > If the door is closed, beeper beeps and shows END. > > All ideas appreciated > > > Did check and looked ok but I have it on a table - he uses it hanging on > the wall so it is possible that the door alignment could be off - except - > he said he took it home and tried it on the table without hanging it. > Maybe something happened in transit. > I usually run these and move the door up and down to assure alignment. > Roger G. > > Mr. Fix-It > Harrisburg, PA 17110 WebSite- http://mrfixit.netfirms.com > rogerfixit@xxxxxxxx > FAX 510-740-3641; Tel: 717-763-7098 (shop) 717-652-1703(home) > > At 11:09 PM 6/18/2004, you wrote: > > >Even though the switches check good how does the alignment look? > >Al Marquardt > >ampm@xxxxxxx > >Al Marquardt Electronic Repair > >206 W Main > >Girardville Pa. 17935 > >----- Original Message ----- > >From: "Roger G" <rogerfixit@xxxxxxxxxxx> > >To: <techassist@xxxxxxxxxxxxx> > >Cc: <hivolts@xxxxxxxxxxxxxxxx>; <becyn@xxxxxxxxxx> > >Sent: Friday, June 18, 2004 5:05 PM > >Subject: [TechAssist] GE JVM140H Range hood Spacemaker 1400 No heat. > > > > > > > REgarding the comments on the Sharp Microwave on TechAssist, > > > Just did a GE with VERY intermittent heating. Resoldered the ckt bd as > > > suggested. > > > It worked every time for me - even before I soldered the bd- and always > >after. > > > Custy took it home - said it does not work. > > > I had checked the micro switches-- chk'd OK. > > > Have you found a similar problem with these GE microwaves? > > > The connectors looked clean - not like the ones where the grease gets into > > > them and turns them brown > > > > > > Roger G. > > > > > > Mr. Fix-It > > > Harrisburg, PA 17110 WebSite- http://mrfixit.netfirms.com > > > rogerfixit@xxxxxxxx > > > FAX 510-740-3641; Tel: 717-763-7098 (shop) 717-652-1703(home) > > > > > > > > > - > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > http://www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: http://www.freelists.org/archives/techassist/