Thanks for the assist. All were bad except the 2 zeners, but still a no go on the fix. Still snow, but now there is red lines in the middle right hand side short verticle longer verticle repeated about 6 times. Does any body have the schematic or service manual for this set? Thanks for any help Lance Harper Fax #626-585-7921 Lharper@xxxxxxxx > -----Original Message----- > From: Charles Belich [mailto:seashell@xxxxxxxxxx] > Sent: Thursday, November 08, 2001 8:55 AM > To: techassist@xxxxxxxxxxxxx > Subject: [TechAssist] Re: Mitsubishi ck-3552r schematic needed > > > > CK-3552R > Symptom: POWERS ON/NO OPERATIONS > Cause #1 > > > 1. SNOW ONLY. CHECK SUPPLIES ON PCB MAIN OFF T901. IF RUNNING > HIGH CHECK FOR > LEAKY CAPACITOR C913 ON PRIMARY SIDE OF TRANSFORMER. IF LEAKY > REPLACE. CHECK > FOLLOWING COMPONENTS AND REPLACE AS NEEDED. * SIGNAL PCB * > MAIN PCB * R780 - > 100 OHM 1 WATT C913 - 100UF AT 10VDC R781 - 270 OHM 1/4 WATT > C952 - 2200UF > AT 50VD C3Z0 - 2200UF AT 50VDC C953 - 100UF AT 50VDC C3Y7 - > 100UF AT 50VDC > C955 - 470UF AT 25VDC C3X8 - 100UF AT 50VDC D704 - 18 V ZENER PART > #264P46704 D705 - 12 V ZENER PART #264P46505 .........Charlie > > > Charles Belich > Slidewire Electronics > MN Mailto:seashell@xxxxxxxxxx > > ----- Original Message ----- > From: "Harper, Lance" <LHarper@xxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Wednesday, November 07, 2001 3:17 PM > Subject: [TechAssist] Mitsubishi ck-3552r schematic needed > > > > Schematic needed. The set has no control functions on the > panel or remote > > after power on. > > > > > > Thanks for any help on this. > > > > Lance > > > > > > Help make your TechAssist online repair tips > > database better! Submit your fixes here: > > http://www.circuitwork.com/techassist/tip/#tips > > To unsubscribe write to: > > techassist-request@xxxxxxxxxxxxx > > with unsubscribe in the subject line. > > > > > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. > ***************************************** Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips ***************************************** To UNSUBSCRIBE write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.