Vs 50603 is a 1998 model, VZ-5 chassis. It's no longer on the Mits website. Sounds more like the A/V switches are bad. One Ic for video, one for audio, normally found on the input jack board or near it on the signal board. Don't have the schematics, but if you have access to VZ-4 or VZ-6 manual it'll get you close. If you don't have those, try looking for 2 similar 14 -16 pin IC's or maybe one 24-30 pin DIP IC in those areas. I think they use 3 pins to switch the inputs on both types of ICs.....no data bus on those . Damon B Telrad Electronics Fort Wayne IN ----- Original Message ----- From: "Gary Pahls" <bec@xxxxxxxxx> To: "Techassist@xxxxxxxxxxxxx" <techassist@xxxxxxxxxxxxx> Sent: Monday, July 11, 2005 3:55 PM Subject: [TechAssist] Mitsubishi VS-50603 - Will not access AV inputs > This unit will not access the AV inputs, it will switch from tuner A to B but has sound only. Channel display works OK. Menu's work fine. When in the channel setup menu it will show the picture in the corner. Also, what chassis is in this set and is the chassis number usually printed on the set or chassis somewhere? > TIA > > Gary Pahls > Beloit Entertainment Center > bec@xxxxxxxxx > -------------------------------------------------------------------------- --- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/